| Plant parameters | Plant value |
| Plant power state | 0% (shut down) |
| Subcritical reactor state | ³2 % |
| Residual heat | 11.5 MW |
| Primary pressure | atmospheric |
| Core inlet temperature | ΠΆ = 343.15 K |
| Reactor coolant level | Correspond to the level of upper part to the MCP vessel or lower. (it is assumed 0/20/0/35 m below the level of upper part to the MCP vessel. |
| Pressurizer water level | 2/8 m (it is determined by the water level in the MCP vessel, which is unsealed and LPSIP flow to the hot leg) |
| SG water level | Dry out |
| Boundary conditions | Value |
| HPSIS tank temperature | 333.15 K |
| Emergency make-up tank temperature | 333.15 K |
| Technical water flow rate through heat exchangers | 2800 m3/h |
| Service water temperature inlet of the heat exchangers | 306.15 K |
| Emergency make-up tank level | 3.1 cm |
| Hydro accumulators temperature | 333.15 K |
| Hydro accumulators pressure | 2.94 MPa |
| LPP flow rate | minimum |